A Fair Repair Range for this repair is not yet available.
Recommended by HUMMER
Change engine oil and filter
Rotate tires and check inflation pressures and wear
Change axle oil
Change engine coolant
Change geared hub oil
Change transmission and transfer case fluid
Change transmission filter
Replace fuel filter
Check air cleaner
Check axles for leaks and damage
Check ball joints for wear
Check battery voltage and condition
Check CDR valve for oil saturation
Check CTIS operation. Verify that system inflates/ deflates tires
Check fluid levels and condition for power steering pump, cooling system (reservoir and surge tank), brakes, transmission, transfer case, geared hubs, and axles.
Check fuel tank vent line filter
Check tire wear and condition
Check torque of wheel half nuts and lug nuts
Check wheel alignment
Check winch operation and cable condition (if equipped)
Clean or replace air filter
Inspect A/C system operation
Inspect all wiring harnesses for frays, splits, missing insulation, and poor connections
Inspect condition of control arms, springs, and shock absorbers
Inspect condition of engine mounts and insulators
Inspect condition of frame rails and crossmembers
Inspect condition of geared hub and axle vent lines
Inspect condition of steering column, U-joints, tie rods, steering arm, center link, and idler arm
Inspect condition of transmission and transfer case vent lines
Inspect exhaust system and shields
Inspect fuel filter and drain/clean if necessary
Inspect fuel injection pump, lines, and fittings for leaks or damage
Inspect fuel tank, lines, and cap
Inspect geared hubs for leaking seals or damage
Inspect halfshaft boots and ball joint seals
Inspect power steering pump, power steering gear, hoses, line, and fittings for leaks or damage
Inspect serpentine belt condition
Inspect service brakes and parking brake
Inspect surge tank, radiator and shroud, A/C condenser, power steering and transmission coolers, and all hoses and fittings for security of mounting, leaks, obstructions, or damage
Inspect transmission/ transfer case shift linkage for wear, binding, and distortion
Inspect U-joints for wear or missing/damaged grease fittings
Lubricate all grease fittings and body lubrication points
Test drive vehicle and complete a functional check of all systems
60,000 Mile Service
HUMMER Maintenance Near Me
Near Anaconda, MT
59711
View:
2003 H1 60,000 Miles Q&A
HUMMER Maintenance Pricing & Schedules
Pricing for Common 2003 HUMMER H1 Repairs & Services
This usually happens with older/less-common vehicles or if the manufacturer no longer makes vehicles. And certain repairs don’t apply to every make & model.